MIL-P-18140(SHIPS)
3.5.5 Driver rating (motor), - The horsepower rating of each motor shall be not less th that
required by the pump under maximum power conditions as determined by actual tests of the identical or
similar equipment. If such data is not available the required horsepower rating of the motor shall be
determined by the following formula:
1. 05 (max. HP. output of the pump)
Horsepower of driver =
(eff. of pump)
The actual motor rating shall be in accordance with Navy standard motor ratings.
3.5.6 Controllers, - Motor controllers shall be in accordance with Specification MIL-C-2174 for
direct current and Specification MIL-C-2212 for alternating current, and shall have the characteristics
as specified in the contract or order.
3.5.7 Diesel engine drivers shall be in accordance with Specification MIL-E-15163 and shall have
the characteristics as specified in the contract or order,
3.5.8 Gasoline engine drivers shall be as specified in the contract or order,
3.6 Identification plates and information plates. -
3.6.1 Identification plates and information plates shall be furnished on each pump, These plates
shall be type A or B in accordance with Specification MIL-I- 15024, except that identification plates of
aluminum or plastic shall not be used.
3.6.2 Identification plates and information plates shall be firmly secured to the equipment with
corrosion resistant metallic screws.
3.6.3 Pump identification plates shall contain data as follows:
(a) Manufacturer's name.
(b) Manufacturer's model or type and size,
Service application,
Manufacturer's serial number,
(e) Salient design characteristics:
(1) Capacity in gallons per minute.
(2) Discharge pressure.
(3) Suction lift,
(4) Speed of shaft in revolutions per minute.
(5) Brake horsepower.
(6) Test pressure,
(7) Viscosity range (operating),
(f) Contract number (and item number for multiple unit orders),
(g) Bureau of Ships stock number,
(h) Section for inspector' s stamp,
3.6.4 Each driving unit and each accessory unit shall have an identification plate in accordance
with the applicable equipment specification,
3.7 Drawings, -
3.7.1 Drawings shall be in accordance with type I of Specification MIL-D-963.
11
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business