MIL-P-53108(ME)
3.11.4 Suction and discharge connections. Suction and discharge connections shall be
6-inch 300 pound raised face flanges, in accordance with ANSI B16.5, and shall be fitted with steel blind flanges including suitable gaskets to protect the pump connections during shipment and periods of non-use. The pumps shall be furnished with pipe adapters for the suction and discharge connections having a 300 pound raised face flange connection on one end and an Inland Petroleum Distribution System (IPDS) 6 inch single groove connection, as shown in figure 2, on the other end. The adapters shall be designed so that when attached to the suction
and discharge connections, the IPDS single groove ends are positioned 9.5 + 1.5 inches vertically from the bottom of the skid. If the suction adapter is not identical to the discharge adapter, each shall be labeled accordingly.
3.11.5 Casing vent lines. The pump casing vent lines shall be routed to a point at the edge of the skid base and shall terminate in a single 3/4-inch pipe. The height of the pipe shall be sufficient to allow a 10-inch vessel to be placed underneath.
3.11.6 Tapered pins. A tapered pin shall be provided on each of the two diagonally opposite pump mounting feet to establish a bench mark for pump-driver alignment.
3.12 Engine. The engine shall be an industrial, turbocharged, diesel engine, selected in accordance with MIL-STD-1410, class II. The engine shall deliver power at its continuous duty rating to meet the pump requirements of 3.10. The engine shall be capable of operating on all fuels specified in VV-F-800 and with JP-8 conforming to MIL-STD-83133 at all ambient temperatures specified in 3.6.1 without degradation of reliability or durability. The engine shall be equipped with, but not limited to, the following:
a. A 24-volt electric cranking system with a charging alternator and batteries suitable for
-25 F starting.
b. Heavy duty air cleaner, dry type, replaceable cartridge, with restriction indicator. c. Fuel filters, primary, water separating type; secondary, with drain cock.
d. Manual engine controls to include a waterproof pushbutton starter switch and a push-pull shutdown control (pull to stop).
e. Automatic engine shutdown controls in the event of engine overspeed, high coolant temperature, low lubricant oil pressure, or pump low suction pressure (device with an
adjustable working range of 0-50 psig. f. Spark-arresting muffler with guard.
g. Drain tube to permit draining the engine oil into a container without soiling other components of the system.
h. Auxiliary charging receptacle conforming to MIL-C-62122 for recharging the batteries from a remote power source without operation of the engine.
i. Cold weather starting aid conforming to MIL-E-52649, type 3. j. Port to sample engine oil for testing.
k. Provisions to lubricate the turbocharger bearing prior to startup. Lubrication of the bearing shall be accomplished without tools or any degree of disassembly and shall
utilize oil already in the engine lubricating oil system. The method of bearing
8
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business