MIL-P-24475 (SHIPS)
3.9.1.2 Parts of the pump rotor for pumps without axially spilt casings shall be fur-
nished disassembled. The shaft for close coupled motor driven pumps shall be furnished
with motor rotor or armature.
3.9.1.2.1 The quantities of individual repair parts shall not be reduced because of
duplication of parts furnished to make the rotor assembly except that standard casing wearing
rings shall not be required.
3.9.1.3 Casing wearing rings shall be machined undersize by at least 0.030 inch on the
radius in order to permit finish maching as required for replacement onboard ship.
3.9.1.4 Repair parts shall be processed in accordance with MIL-P-15137 (see 6.2).
3.9.2 Tools.
3.9.2.1 Special tools required for the maintenance and repair of the pump units shall
be furnished. The number of sets of special tools shall be as specified (see 6.1).
3.9.2.2 The special tools shall include the following, as applicable:
Complete set of special wrenches of forged steel with hardened jaws.
(a)
(b)
One impeller pulling tool.
One set of ball bearing pulling tools.
(c)
(d)
Any other special tools necessary for the proper maintenance of the units
in service.
3.9.2.3 Tools which are available in the Federal Supply Catalog, such as common wrenches
and standard pullers, will not be required.
(Copies of this catalog may be consulted in the
Office of the DCAS.) Standard complete or limited sets of pullers or parts of puller sets
in accordance with GGG-P-781 shall be identified as to the type and use in notes on the out-
line or section assembly drawings. Special tools shall be detailed and included in the list
of material.
3.9.3 Each metal box containing onboard repair parts shall contain a list entitled
"list of onboard repair parts." It shall be not less than nominal 8-1/2 by 11 inches in size.
3.9.3.1 The format of the list shall include a heading and columns of data for the
items listed. The heading shall include titles and applicable entries similar to the follow-
ing:
Reproduced from drawing number
Number of Ships
Application
Contract number
Manufacturer
units per ship
Quantities are for
.
The columns shall include.
Piece number
Name of part
Quantity
Drawing number
Federal stock numbe r
Additional columns may be used as applicable.
3.9.3.2 The list shall be so treated as to be resistant to oil, water and fading.
3.9.4 Repair parts for drivers and control equipment shall be furnished in accordance
with the applicable specifications.
4.
QUALITY ASSURANCE PROVISIONS
4.1 Respo nsibillty for inspection. Unless otherwise specified in the contract or
purchase order, the supplier is responsible for the performance of all inspection require-
ments as specified herein. Except as otherwise specified in the contract or order, the
supplier may use his own or any other facilities suitable for the performance of the inspec-
tion requirements specified herein, unless disapproved by the Government. The Government
reserves the right to perform any of the inspections set forth in the specification where
such inspections are deemed necessary to assure supplies and services conform to prescribed
requirements.
14
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business