MIL-P-24475 (SHIPS)
3.5.1.5.2 Outline drawings in addition to the certification data required by MIL-D-1000/2
shall contain the following:
Dimensional outline assembly drawing of the pump with its prime mover, bedplate
(a)
and attached auziliaries.
Complete performance data of pump, prime mover, and attached auxiliaries, if
(b)
applicabel.
Complete equipment performance curves, based on actual tests (the original
(c)
submission may show design performance curves vice test curves) .
Table of weights of individual components and weight of complete unit.
(d)
Shipbuilders connections showing size, type and dimensions of flanges.
(e)
(f)
Center of gravity of the pump component and of the complete assembly.
Radii of gyration of complete assembly about each of the three principal axes
(g)
(required only if equipment is sound isolated)
Identification of system in which installed (if known).
(h)
Critical speed.
(1)
Maximum thrust load.
(J)
The endurance test, high impact shock tests and nondestructive tests (if
(k)
performed) and the NAVSEC or command or agency letters approving these
reports or extension of any tests.
In addition the outline drawing shall include overall dimensions of the
(1)
complete unit including locating dimensions of all fittings and connectins,
the space required for removal and replacement of parts for maintenance,
and mounting information
3.5.1.6 Onboard repair parts list. A list of onboard repair parts shall be furnished.
This list shall be prepared on Provisioning List forms in accordance with MIL-P-15137 (see
6.2). This list shall be furnished whether or not the parts are required in the pump contract
or order. This list shall not be modified to indicate parts or quantities of parts furnished
under supplementary or separate contracts or orders. This list is intended as a record of
recommendations of the manufacturer and purchaser at the time of equipment drawings review.
The list of onboard repair parts actually purchased shall be prepared as required by MIL-P-
+5137 (see 6.2).
3.5.1.7 Basic design drawings. Basic design drawings covering pumps under this
specification are intended for submittal to NAVSEC for review prior to and independent of
invitations for bids. Each drawing may cover a range of sizes of pumps so long as they
are of the same basic design.
3.5. 1.7.1 Contents of basic design drawings. These drawings shall consist of small
scale (not necessarily to scale plan and elevation views showing over-all dimensions. If
the plans cover a family of pump sizes all of the same design, the dimensions may be
The range of capacities, pressure and speeds shall be shown. The main part
tabulated.
of these drawings shall be undimensioned sectional assembly with complete list of material
which shall include every part required in the pump assembly.
If materials of some parts
may change with various pump characteristics or with differing fluids to be pumped, a table
shall be included to show these variations. Alternate subassembly arrangement of different
parts may be included as desired.
3.5.1.7.2 Detail drawings of individual parts are not required in connection with
basic design drawings, but may be included if desired by the manufacturer for clarification,
or to obtain advance review by NAVSEC.
3.5.2 Material identification.
3.5,2.1 Preferred material reference. Where materials of identical or equal quality
can be identified by more than one specification or standard, the drawings need reference
only one such specification or standard. In selecting the specification or standard to be
referenced the following is the order of preference:
Federal specification.
(a)
(b)
Military specification.
Industry and Technical Society specification or standard.
(c)
(d)
Manufacturer's specification or standard.
10
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business