MIL-P-17861F
SOCIETY OF AUTOMOTIVE ENGINEERS, INC.
(SAE)
SAE J534 - Lubrication Fittings.
SAE J1349 - Engine Power Test Code - Spark Ignition and Compression
Ignition - Net Power Rating.
(Application for copies should be addressed to the Society of Automotive
Engineers, Inc., 400 Commonwealth Drive, Warrendale, PA 15096.)
TIRE AND RIM ASSOCIATION, INC.
(TRA)
TRA Yearbook.
(Application for copies should be addressed to the Tire and Rim Association,
Inc., 3200 West Market Street, Suite 304, Akron, OH 44313.)
(Non-Government standards and other publications are normally available from
the organizations that prepare or distribute the documents. These documents
also may be available in or through libraries or other informational services.)
2 3 Order of precedence. In the event of a conflict between the text of
this document and the references cited herein, the text of this document takes
precedence. Nothing in this document, however, supersedes applicable laws and
regulations unless a specific exemption has been obtained.
3.
REQUIREMENTS
3.1 Description. Each pump unit shall consist of an integrally self-priming
centrifugal pump as specified in the Hudraulic Institute Standards, a
direct-connected internal combustion engine, and a common base, skid, or wheel
mounting. The pump capacity in gph listed in 1.2 to identify pump sizes shall
be interpreted as the nominal capacity. The size of the pump listed in 1.2
indicate suction and discharge openings, which shall be of identical dimension
on each size, The applicability of class to size shall be as specified in
table I, as represented by an "X" in the column under the size of pump.
3.2 First article. When specified in the contract or purchase order, a
sample shall be subjected to first article inspection (see 4.2.1 and 6.4),
3.3 Codes and standards. The pump shall conform to the requirements of the
CPB Contractors Pump Manual as applicable,
3.4 Materials. Materials used shall be free from defects which would
adversely affect the performance or -maintainability of individual components or
of the overall assembly. Materials not specified herein shall be of the same
quality used for the intended purpose in commercial practice. Unless otherwise
specified herein, all equipment, material, and articles incorporated in the work
covered by this specification are to be new and fabricated using materials
produced from recovered materials to the maximum extent possible without
jeopardizing the intended use. The term "recovered materials" means materials
which have been collected or recovered from solid waste and reprocessed to
become a source of raw materials, as opposed to virgin raw materials. Unless
otherwise specified, none of the above shall be interpreted to mean that the use
of used or rebuilt products are allowed under this specification.
5
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business