MIL-P-17945A(SH)
3.2.21 Pumps shall have constantly rising head capacity curves.
3.3 Identification plates.
3.3.1 Identification plates shall be type A or B in accordance with MIL-P-15024 and
MIL-P-15024/5, and shall be of material other than plastic or aluminum.
3.3.2 Identification plates shall be secured to equipment with corrosion-resistant
metallic screws.
3.3.3 Pump identification plates shall contain data as follows:
(a)
Manufacturer's name
Manufacturer's model or type and size,
(b)
Service application.
(c)
Manufacturer's serial number.
(d)
Salient design characteristics:
(e)
(1) Capacity in gallons per minute (gal/rnin).
(2) Total head in pounds per square inch
(3) Speed of shaft in revolutions per minute (r/rein).
(4) Brake horsepower (bhp).
(5) Test pressure.
(6) Special data vital to the unit:
(a.) Suction pressure.
(b.) Submergence.
(f)
Contract number (and item number for multiple unit orders).
National stock number.
(g)
Section for Defense Contract Administration Services (DCAS) stamp.
(h)
3.3.4 Each driving unit and each accessory unit shall have an identification plate in
accordance with the applicable equipment specification.
3.4 Repair parts and tools.
3.4.1 Onboard. Onboard repair parts of the types and quantities shown in table II
shall be furnished as required (see 6.2.1).
3.4.1.1 The pump rotor assembly for flexible-coupled units shall be completely assembled
ready for installation in the unit for which intended and shall include any nonrotating parts
which can be installed only by removing some rotating part or parts of the pump rotor.
3.4.1.2 Pump rotor assemblies for motor driven close-coupled pumps shall be furnished
disassembled.
Shaft shall be furnished with motor rotor or armature.
3.4.1.2.1 The quantities of individual repair parts shall not be reduced because of
duplication of parts furnished to make the rotor assembly.
3.4.1.3 Repair parts for the drivers and associated equipments shall be furnished in
accordance with the applicable equipment specification,
7
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business